Table of Contents


gluDisk - draw a disk

C Specification

void gluDisk( GLUquadric* quad,
    GLdouble inner,
    GLdouble outer,
    GLint slices,
    GLint loops )

eqn not supported


Specifies the quadrics object (created with gluNewQuadric).
Specifies the inner radius of the disk (may be 0).
Specifies the outer radius of the disk.
Specifies the number of subdivisions around the z axis.
Specifies the number of concentric rings about the origin into which the disk is subdivided.


gluDisk renders a disk on the z = 0 plane. The disk has a radius of outer, and contains a concentric circular hole with a radius of inner. If inner is 0, then no hole is generated. The disk is subdivided around the z axis into slices (like pizza slices), and also about the z axis into rings (as specified by slices and loops, respectively).

With respect to orientation, the +z side of the disk is considered to be "outside" (see gluQuadricOrientation). This means that if the orientation is set to GLU_OUTSIDE, then any normals generated point along the +z axis. Otherwise, they point along the -z axis.

If texturing has been turned on (with gluQuadricTexture), texture coordinates are generated linearly such that where $ r ~=~ "outer" $, the value at (r, 0, 0) is (1, 0.5), at (0, r, 0) it is (0.5, 1), at (-r, 0, 0) it is (0, 0.5), and at (0, -r, 0) it is (0.5, 0).

See Also

gluCylinder(3G) , gluNewQuadric(3G) , gluPartialDisk(3G) , gluQuadricOrientation(3G) , gluQuadricTexture(3G) , gluSphere(3G)

Table of Contents