/etc/X11/xorg.conf file tells the X server what kind of
video card and mouse you have. You must create it to tell the
server what specific hardware you have.
You'll need info on your hardware:
For details about the
xorg.conf file format, refer to the
xorg.conf(5) manual page.
Once you've set up a xorg.conf file, you can fine tune the video
modes with the
X11R6.9 has support for the mouse driver included in
the wscons console driver introduced by NetBSD 1.4. Specify
wsmouse'' as the protocol and ``
/dev/wsmouse0'' as the
/etc/X11/xorg.conf if you're using NetBSD 1.4 or later
with a PS/2 mouse.
For older releases, the NetBSD pms mouse driver handles PS/2 style
mice as Busmouse. Specify the protocol as ``
busmouse'' in the
mouse section of your
xorg.conf file if you're using a PS/2
mouse with NetBSD 1.3 or former releases.
Only standard PS/2 mice are supported by this driver. Newest PS/2 mice that send more than three bytes at a time (especially Intellimouse, or MouseMan+ with a wheel) are not supported by NetBSD 1.3 and former releases.
See README.mouse for general instruction on mouse configuration.